Belair 20E - System Settings; Country of Operation

BelAir20E User Guide System Settings
April 2, 2012 Confidential Page 49 of 255
Document Number BDTM02201-A01 Standard
System Settings
This chapter contains procedures for managing BelAir20E parameters as
follows:
• “Country of Operation” on page 49
• “System Identification Parameters” on page 50
• “Custom Fields” on page 50
• “Configuring the System Date and Time” on page 51
• “GPS Coordinates” on page 53
• “LED Control” on page 53
• “Setting the Network Egress Point” on page 54
• “Limiting Broadcast Packets” on page 54
• “Displaying Unit Inventory Information” on page 55
• “Defining a Maintenance Window” on page 55
• “Displaying System Up Time” on page 55
• “Displaying the Running Configuration” on page 56
• “Restarting the Node” on page 56
• “Creating and Using Script Files” on page 56
• “Enabling or Disabling Session Logging” on page 56
Country of
Operation
/system/show country [detail]
/system/set country <country_code>
Note: These commands apply only to BelAir units purchased outside of the
United States of America and its territories. For units purchased in the
United States of America and its territories, the unit’s country code is
US and cannot be changed.
These commands allow you to adjust the radios in your unit to conform to the
regulatory requirements for your country. This includes valid radio channel
ranges as well as transmit power levels and the use of Dynamic Frequency
Selection (DFS), a regulatory requirement in some jurisdictions.