Belarus 1025/1025.2/1025.3 Section E. .Preparation for operation
3. To switch on power, position or mixed
control mode, lift RMU to topmost
position use handle of power control
lever (shown with an arrow).
4. Put switch (1) to vertical position,
having released lever (3) of the control
tie-rod, connecting power lever with
mixer.
5. Set handle (4) of modes switch to
required position, having aligned
marks imprinted on handle circular
dial with mark “V” on the upper control
panel plate:
• I — Position control
• III —Power control
• I - III — Zone of mixed control
6. Interlock switch (1) with lever (3)
having put switch projection extension into
lever groove.
To Next Page
