Belarus 1025/1025.2/1025.3 Section E. Preparation for operation
E10
Having selected one of control modes, do
the following:
1. Loosen clamp fastening (1) and shift it
to front position.
2. Move handle (2) of power control from
“neutral” forward to lower an
implement to required position (over
soil or inside soil).
Further on move the lever forward to
increase tillage depth and visa versa.
3. After depth of soil tillage is set, move
clamp (1) into handle (2) and stop it.
This will limit lever travel during
subsequent operations.
To lift the implement at the end of furrow
shift handle (2) to position “lift” and hold it
in this position until the implement is fully
lifted, and then release it. The lever will
automatically adopt position “neutral”. To
continue operation at given tillage depth
move handle forward to the end.
Note: To eliminate jerks due to high
speed of correction, turn hand wheel of
sensitivity control in the clockwise
direction.
To lower mounting unit without the
implement, move control handle (2) of
power regulator to front end position and
hold the lever until the mounting unit
adopts required position. After the handle
is released it automatically returns to
“intermediate neutral” at the end of control
zone.
A – Lowering
B – Control zone
C – Neutral
D -Lift
To Next Page
