Oven Timer Operation
Other Notes On Timer Operation
1. When cooking Automatically the cook period can be checked at any time
simply by pressing the “ ” button.
2. When cooking Automatically the Stop time can be checked at any time by
simply pressing the “ ” button. (This also can be altered at any time by
following step 4 above.
3. Having set a cooking period and Stop time an electronic device stores the
information. The device within the timer will switch the oven on at the
required start time.
4. If a mistake is made and is not readily rectified alter the cook period to show
(as per Step 3 above) then press the “ ” (see Step 7 above)
and start the sequence again.
5. After an Automatic sequence the bleeping sound could also be switched off
by pressing any of the three buttons ( , , ).
However the cooker cannot be re-used until the timer has been set to manual
operation, this is achieved by pressing the “ ” button (see Step 7 above).
6. If at any time the display shows three flashing zero’s 0.00 . It is likely that the
electricity supply to the oven has been interrupted. Reset the timer to the
correct time of day. Food in the oven may therefore not have been cooked,
before serving check food is thoroughly cooked.
7. To give yourself more time to set each function press and hold the required
function button and at the same time press “+” or “–” button.
NOTE: Between the hours of 10.00p.m. and 6.00a.m. the intensity of the display
reduces.
14
To Next Page
Loading...
