To Next Page
C
costapaulaAug 16, 2025
What to do if my Belmash SDM-2000 suddenly stopped during operation?
- SShane CuevasAug 16, 2025
If your Belmash Saw suddenly stopped, check the voltage. If the voltage is normal, restart the machine in 15-20 minutes.
What to do if my Belmash SDM-2000 suddenly stopped during operation?
If your Belmash Saw suddenly stopped, check the voltage. If the voltage is normal, restart the machine in 15-20 minutes.
Why does my Belmash Saw vibrate during operation?
Your Belmash Saw might be vibrating because the knives are incorrectly matched and installed improperly. To fix this, install the knives and holding element with the appropriate weight, and adjust their position. Another cause might be a deformed saw blade, in which case you should replace it.
What to do if the motor of my Belmash Saw becomes overheated?
If the motor of your Belmash Saw is overheating, it could be due to machine overload from high-feed operation; reduce the continuous feed of the process material. Another reason could be that the wood material is wet; replace the workpiece with a dry one.
How to fix a Belmash SDM-2000 Saw that is connected to the mains but does not operate?
If your Belmash Saw doesn't operate when connected to the mains, check the main socket voltage with another known-good household appliance. You may need to correct the fault or replace the outlet with the patch cable plug. It may also be necessary to replace the switcher at the service center.
What to do if the motor operates but the cutter block is not rotating on my Belmash Saw?
If the motor of your Belmash Saw operates, but the cutter block is not rotating, the belt is likely torn. Replace the belt to resolve this issue.
What to do if my Belmash Industrial Equipment suddenly stops?
If your Belmash industrial equipment suddenly stops, first, check the voltage. If the voltage is OK, the thermal protector may have been activated. In this case, wait 15-20 minutes and then try starting the machine again.
Why is my Belmash Industrial Equipment motor overheating?
The electric motor of your Belmash industrial equipment may be overheating because the machine is overloaded with material. Try reducing the amount of material being processed. Another possible reason is that the wood is too moist. In this case, replace the blank with a dry one.
Why does my running Belmash Industrial Equipment generate strong vibration?
Strong vibration in your running Belmash industrial equipment can be caused by improper or incorrectly mounted knives. Adapt the knives and fixation parts by weight and adjust their position. Another cause may be a deformed saw blade. If so, replace the saw blade.
How to fix a Belmash Industrial Equipment machine that is powered ON but fails to start?
If your powered-on Belmash industrial equipment fails to start, check the power line voltage with another working device. Also, ensure there's good contact between the socket and the connecting cord plug; if there's a malfunction, eliminate it or replace the plug. Finally, the switch might be out of order, so eliminate the malfunction or replace the switch.
What to do if the motor is running but the cutter-block is not rotating in my Belmash Industrial Equipment?
If the motor of your Belmash industrial equipment is running but the cutter-block isn't rotating, the belt is likely torn. Replace the belt.
General| Power consumption | 2000 W |
|---|---|
| Supply voltage | 230 V |
| Motor type | Induction |
| Spindle speed | 2800 RPM |
| Saw blade diameter | 250 mm |
| Saw blade bore diameter | 30 mm |
| Weight | 5.5 kg |