33
Electric motor becomes
overheated
The machine is overloaded
because of the high-feed
operation
The continuous feed of the
process material should be
reduced
The wood material is wet Replace the workpiece
The motor operates but
the cutter block is not
rotating
The belt is torn Replace the belt
The work machine
vibrates
The knives are incorrectly
matched and installed in
the improper way
Install the knives and holding
element with the appropriate
weight, adjust their position
The saw blade is deformed Replace the saw blade
The machine has
suddenly stopped during
operation
There is no voltage Check the voltage
The thermal protection
shield was activated
Restart the machine in 15-20 min.
14. STORAGE
Machines are designed for storage in closed or other naturally ventilated rooms without
artificially controlled climatic conditions where variations in temperature and air humidity is
substantially less than in the open air (such as stone, concrete, metal heat-insulated, and
other unheated warehouses, located in macroclimatic areas with moderate and frigid
climates).
It is necessary to pay attention to the labeling requirements on the individual packaging.
Keep the machine out of children’s reach.
15. TRANSPORTATION
The transportation of the machines is performed in closed vehicles.
The transportation of the machines is performed by two persons, holding the handles of the
package.
It is necessary to comply with the labeling requirements on individual packaging.
16. DISPOSAL
Never dispose this machine and its parts together with unsorted municipal waste.
The machine parts made of aluminum and plastics are labeled. That allows sorting and
recycling wastes.
Devices and tools of the machine, which have reached the end of their working life, must be
collected and disposed of separately from household waste material.
The list of the details, which do not meet the terms of this limited warranty:
saw blade;
belt;
slicing blades;
drill chuck;
plastic insert of the saw blade;
To Next Page
Loading...