22
installation. If required, repeat the installation again.
The cutting edge of properly installed knives should touch (up to 0,1 mm) the lower edge of
the ruler 12 during cutting block rotation.
10.4 Machine startup
Machine startup is performed with the help of the switcher after adjusting the processing
type. The switcher is located on the swivel control panel 18 (Fig. A) that has two positions:
1 position – to operate in the jointing and cutting mode. The swivel control panel with the
switcher is installed on the accessible area from the left side of the outfeed table 3;
2 position – to operate in the milling mode. The swivel control panel with the switcher is
turned and installed all the way to the right in the accessible work area.
To change the switcher position, release the flywheel 21, turn the swivel control panel with
the switcher and fix it again with the flywheel.
To start up the machine it is necessary:
to connect the machine’s plug to the mains;
to unlock and open the switch cover, push the green button.
To switch off the machine it is necessary to:
push the red button;
or close the switch cover.
The start-up time of the machine is less than 5 seconds. In case the machine fails to start, turn
it off with the switcher. If the problem remains, restarting is performed in no event sooner
than 1 min.
After the end of work, the switch cover must be shut off.
11. BASIC OPERATIONS
11.1 Рlaning (jointing) on surface, along ribs and at an angle (along ribs)
Before starting, it is recommended to make the following adjustments:
to install the planing table;
to adjust the planing depth;
to adjust and install the fencing;
to install the ruler;
to install the holding device (for workpieces with thickness less than 50 mm).
To switch to the planing mode it is necessary to lower the saw blade below the table level
until the indicator needle will be in line with the mark "min" on the cutting depth scale
(p.11.2.2).
To Next Page
Loading...