Belmash SDM-2000 - Parameters; Marking and Packing

16
Keep your hands at a safe distance from the cutting place.
The workpiece supply should be steady (without jerks). The table speed should provide the
smooth running of the machine to avoid overloading.
To process short workpieces (with length less than 300 mm), use special devices for secure
workpiece supply (pushers).
8.6 Devices for secure supply of the workpiece
To ensure secure supply, use wooden pushers that are designed to fit the specific workpiece.
The pushers are made by the user himseft. The minimal length of the pushing part should be
at least 400 mm.
The examples of the pushers are shown in the Fig. F.
Fig. F
Pushing rails
9. MARKING AND PACKING
There is a plate with information about the parameters of the power supply on the machine
stand. It is recommended to comply with these requirements when connecting the machine
to the network.
It is necessary to observe the symbols on the packaging during transportation and storage.
400
50
S=25
90˚
25˚±5˚
Ø125 mm
Ø 250÷315 mm
85÷117 mm
Ø 55 мм
230÷270 mm