Belmash SDM-2000 - Setting-Up Procedures

17
Consider the tool sizes and do not use adapters for them. Use the tool recommended by the
manufacturer. When working, consider the maximum allowable finished dimensions.
Information on the types of processing is listed on the label on the fencing of the 30 (Fig. B1)
saw blade below the table level.
There is a threat-warning label on the swivel control panel 18.
Do not put your hands in the working area the machine is switched on. It
may result in risk of injury due to rotating parts.
Use a dust mask.
Always wear personal protection equipment to prevent hearing damage. The
noise exposure can cause permanent hearing loss.
Wear eye-protection goggles.
Never dispose this tool together with unsorted municipal waste. In
accordance with the European Directive 2002/96/EC on waste electrical and
electronic equipment and its implementation into national law,
nonfunctioning power tools must be collected separately and recycled in an
environmentally suitable manner.
There is an icon on the lever 27 showing moving direction when lifting or
lowering the saw blade.
The machine is packed in an individual carton box with two handles.
10. SETTING-UP PROCEDURES
During setting-up procedures it is necessary to perform:
 assembly;
 installation;
 knife setting;
 startup.
10.1 Assembly
First of all, you must set up the machine on the table and assemble the auxiliary machinery
and fencing included in the scope of delivery.
 Adjust the saw blade insert (p. 10.1.1);