Belmash SDM-2000 - Intended Use; General Information

4
2. INTENDED USE
The machine relates to equipment for the domestic individual use.
The hand-fed machines are used for processing of wood and analogous hard materials
(cardboard, plywood, wood chip boards) by planing, cutting, milling and drilling in order to
give them the required shapes and sizes.
Do not use the machine for other purposes. It is not allowed to process metals, stone,
asbestos-cement materials, soft plastic and rubberlike materials
With appropriate adjustment the machine can perform the following types of processing:
 planing (jointing) on surface or along ribs;
 angular planing (jointing, along ribs);
 longitudinal and cross cutting;
 longitudinal angular cutting with the use of a ruler;
 angular cross cutting with the use of device;
 milling with disc cutters;
 milling with end cutters;
 drilling.
3. GENERAL INFORMATION
The machine can be operated outdoors, under cover, indoors, except for residential premises.
Climatic service conditions:
 altitude above the sea level – up to 1000 m;
 environment temperature from +5 to +40°С;
 environmental relative humidity – up to 80%, at a temperature of +20°С.
It is not allowed to operate the machine under the impact of drops and splashes, as well as
outdoors during rain, fog, snowfall, strong wing, and storm.
The power of the machine is supplied by a single-phase AC with an earthed positive earth.
BELMASH SDM-2200 и BELMASH SDM-2500 machines shall be used in the electrical grids
with a nominal impedance z
max
=0,354 ohm. The user must agree on the rated load capacity
sufficient for the mentioned above machines with Electric Inspection Service.
Type of engine – asynchronous, single-phase, with the working capacitor, intermittent
operating status – S6-40%.
The equivalent and maximum sound levels are as follows: 80 dBA and 90 dBA relatively.
The machine has a built-in disconnect device from the power supply during
asynchronous
engine overheating. Restarting of the machine can be performed after the electric motor has
cooled down to the ambient temperature.
To connect the external exhaust units in order to collect dust and cutting wastes, the
woodworking machine has three pipes:
 a pipe with 63 mm in diameter on casing for chip removing 24 (Fig. А);
 a pipe with 38 mm in diameter on casing of saw blade 30 (Fig. А);
 a pipe with 28 mm in diameter on fencing of saw blade 29 (Fig. А).
The external exhaust unit should be suitable for removing cutting wastes.