8
3.1.3 Flip the LCD monitor up towards the front.
NOTE:
• The stand joints are designed to be tight to provide stability in operation.
So, you might need to apply some force to maneuver the Terminal.
• Make sure always lift the stand and display on the lower hinge to the
position "a" before adjusting the upper hinge.
3.2 Installing the Power Cord, Power Adapter, and Network Cable
3.2.1 Place the Touch Terminal on a soft and flat surface, with the LCD panel facing
the down. Remove the cable compartment cover and the connector cover.
To Next Page
Loading...
Need help?
General
