34
unfasten the clamps that x the wiring harness, and take out the battery
waterproof cover.
6. Remove the series wires from the battery terminals.
7. Pull out the battery from back to front until the battery to be replaced is
taken out. The battery is heavy, please handle with care to prevent the
battery from being damaged by collision.
8. Upon removal, cover the battery pack terminals with heavy-duty adhesive
tape. Recycle or dispose of batteries properly.
9. Put in the new battery from the front to the back, and place it according to
the position when it was taken out.
10. In the reverse order of disassembly, install the battery waterproof cover,
battery xing plate and screw in sequence.
11. Connect the battery power cord to the plug of the riding mower, and then
x it with a wire clip.
12. Connect the cable between the charging socket and the riding mower,the
round hole of the cover plate of the upper cover penetrates upwards.
13. Fix the rear cover on the frame with screws, and connect the upper joint of
the seat sensor cable to the lower connector connection.
14. Reset the seat. Sit on the seat, insert the key to turn ON the power switch,
and check whether the electricity meter is displayed normally.
NOTE
The product contains lead-acid batteries. Local regulations may prohibit
disposal of lead-acid batteries in ordinary trash. Consult your local
waste authority for information regarding available recycling and /or
disposal options.
To Next Page
Loading...
