Instruction Manual for DAC3 HGC and DAC3 L with 2.X Firmware Page 26
AC Power-Entry and Fuse Module
Input Voltage Range
Note: The DAC3 is equipped with a universal
power supply. There is no voltage selection
switch. AC voltage range is 88-264 VAC, 50-
60 Hz.
Power Cord
Note: The AC power input uses a standard
IEC type connector. One USA-compatible
power cord is included with DAC3 converters.
IEC style power cords in country-specific
configurations are available in your locality.
Caution: Always use a grounded power
cord. The DAC3 is equipped with a
standard IEC power entry module. Use
an IEC power cord that is equipped with
the appropriate connector for your
location. Cords are available from your
dealer.
Fuses
Caution: For continued fire hazard
protection always replace the fuses with
the correct size and type (0.5A 250 V
Slo-Blo
®
5 x 20 mm – Littelfuse®
HXP218.500 or equivalent). The fuse
drawer includes two fuses. Always
replace both fuses at the same time.
To Next Page
Loading...
