Benchmark DAC3 HGC - Unbalanced Analog Inputs; Status Display; AC Power Requirements; Dimensions

Instruction Manual for DAC3 HGC and DAC3 L with 2.X Firmware Page 67
Unbalanced Analog Inputs
Number of Unbalanced Analog Inputs
4
Input Connector
RCA
Input Impedance
20 K Ohms
Analog Input Clip Point
+18.5 dBu (6.5 Vrms)
Input Sensitivity
+8.2 dBu (2 Vrms)
Bandwidth
> 500 kHz, -0.6 dB at 200 kHz
THD+N (Analog to Analog, 2 Vrms in, +24 dBu out)
-110 dB (0.00032%)
AC Power Requirements
Nominal Operating Range
100 – 240 VAC, 50 - 60 Hz
Min/Max Operating range
90 – 260 VAC, 47 - 63 Hz
Power
< 0.5 Watts Standby
12 Watts Typical Program
15 Watts Maximum
Fuses (2 required)
5x20 mm, 0.5 A 250 V Slo-Blo
®
Type
Dimensions
Form Factor
½ Rack Wide, 1 RU High
Depth behind front panel
8.5” (216 mm)
Overall depth including connectors
9.33” (237 mm)
Width
9.5” (249 mm)
Height
1.725” (44.5 mm)
Weight
DAC3 only
3 lb.
DAC3 with accessories and manual
4 lb.
Shipping weight
7 lb.
Status Display
Indicators - Type and Location
16 LEDs on Front Panel
Selection/Status Indication
1 – Dim/Mute
1 - Polarity
7 – Input
1 – Bypass/Calibrated Output
2 – Word length
4 – Sample Rate