BENDIX VORAD VS-400

Product Safety Information
11
Step Procedure
C 1. VehicleIgnition:Key-ON,Engine-OFF.
2. Measure for ignition voltage on pins 4 and 5 on the harness connector.
a. If the voltage is within 0.6 volts of the battery voltage measured in Step A.
i. Proceed to Step D.
b. If the voltage is less than 0.6 volts of the battery voltage measured in Step A or open.
    i. TestFailed.Checkcomponentfuse.TroubleshootpowersupplytotheDIUforopen/corroded
connections or shorts to ground and repeat Step.