EasyManuals Logo

BENDIX VORAD VS-400 User Manual

BENDIX VORAD VS-400
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
General Information
32
Diagnostic Trouble Code (DTC)
Isolation Procedures
Component Code: 92
(SA 42, SPN 886, FMI 14)
Forward Looking Radar Not Detecting Objects or Radar Blocked
Overview
This code indicates that the Forward Looking Radar (FLR) has not detected a target in an excessive amount of time or has become
blocked.
Diagnostic Trouble Code (DTC) Detection
When the FLR has gone a period of time without receiving any reflected radar signals this Diagnostic Trouble Code (DTC) is set. This
may simply indicate that the vehicle has been in an extremely desolate area without any vehicles or objects to reflect its radar signals.
Non-vehicular objects such as road signs, highway overpasses and background trees should provide enough radar signals to prevent this
Diagnostic Trouble Code (DTC) from being set. This Diagnostic Trouble Code (DTC) may also indicate that the FLR has become blocked by
mud, snow, ice, or other debris.
Symptom
The Bendix
VORAD
®
VS-400 Collision Warning System and the Bendix
SmartCruise
®
adaptive cruise control will fail to operate, however,
the driver will have access to conventional cruise control. The Driver Interface Unit (DIU) will illuminate an orange DTC light and display a
message indicating the Diagnostic Trouble Code (DTC) condition. If the VS-400 system once again begins to detect objects, the condition
will clear and the system will resume normal operation.
Possible Causes
• ObstructedRadarView
• CorrectOperation,butwithalengthytimesincethelastradarobjectwasdetected
Repair Procedure
Active Diagnostic Trouble Code (DTC) Steps to Perform
Code 92, FMI 14
1. Check the Forward Looking Radar for debris buildup (snow, mud, etc.) or if the radar's
view is being obstructed.
Note: This Diagnostic Trouble Code (DTC) is automatically set inactive after each
power cycle.
2. Road test vehicle and make sure the Diagnostic Trouble Code (DTC) condition has
cleared.
3. Test Complete.

Table of Contents

Other manuals for BENDIX VORAD VS-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BENDIX VORAD VS-400 and is the answer not in the manual?

BENDIX VORAD VS-400 Specifications

General IconGeneral
BrandBENDIX
ModelVORAD VS-400
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals