HD-9 Series Four-Post Lifts 32 P/N 5900123 — Rev. N2 — November 2023
Four-Post Lift Flex Tube Kit
The following provides installation guidance for the Flex Tube Kit (5216139) on HD-9 Series four-post
Lifts. The Flex Tube is designed to route and protect Hydraulic, Pneumatic and in some cases
Electrical lines from becoming entrapped and damaged under a Lift Platform.
Installing the Flex Tube Kit
The Flex Tube Kit consists of a 2,000 mm Flexible Tube
(5570053), two Connectors (5555555) and two Plastic Nuts
(5535050).
To install the Flex Tube Kit:
1. Use a Forklift or Shop Crane to raise the Runways to the Top
Lock as described in the Installation Manual.
2. Install one Connector on the Powerside Platform opening near
the Power Unit and secure. Refer to the figure on the right.
3. Install one end of the Flex Tube into the connector. Refer to
the figure below.
4. Note the recommended length of the Flex Tube for your Lift in
the Flex Hose Length Table; below.
5. Cut so as to provide an appropriate “service-loop” with the
flex tube. Then measure twice, mark, then cut the Flex Tube to the correct length indicated
±25mm (±1 in). The free end of Flex Tube hangs in place for now.
Note: The ideal Flex Tube length has a moderate service loop to keep the lines
away from the moving platform.
Flex Hose Length Table
HD-9ST 1,170 mm 96 in.
HD-9STX 1,170 mm 79.75 in.
HD-9 1,320 mm 52 in.
HD-9XL 1,320 mm 52 in.
HD-9XW 1,320 mm 52 in.
HD-9EWT 1,320 mm 52 in.
To Next Page
