BendPak HD-9 Series - Introduction and Safety Information; Models Overview

HD-9 Series Four-Post Lifts 4 P/N 5900123 — Rev. N2 — November 2023
Table of Contents
Introduction 4 Operation 6
7
Shipping Information 5 Maintenance 7
0
Safety Considerations 5 Troubleshooting 7
4
Components 8
Wiring Diagrams 75
Specifications 10 Labels 7
7
FAQs 13 Parts Drawings
80
Installation Checklist 14 ALI Store 9
4
Installation 1
5
Introduction
This manual describes the following ALI- and CE-certified Four-Post Lifts:
• HD-9. Four-Post Lift with an overall width of 111.83 in., raising Vehicles up to 9,000 lbs. (4,082
kg).
• HD-9ST. Four-Post Lift with an overall width of 100.25 in., raising Vehicles up to 9,000 lbs. (4,082
kg).
• HD-9XL. Has the same overall width as the HD-9, but with extended length (198 in.).
• HD-9STX. Has the same overall width as the HD-9ST but with a higher rise (82.165 in.) and
extended length (198 in.)
• HD-9XW. Has the same overall width as the HD-9, but with a higher rise (82.165 in.) and
extended length (198 in.).
• HD-9EWT. This lift is similar to the HD-9XW, but more than 6 inches wider. Better
accommodates wide cars and off-road vehicles.
This manual is mandatory reading for all users of the HD-9 Series, including anyone who installs, uses,
maintains, repairs, or wants to know more about them.
⚠ DANGER Use care when installing, operating, maintaining, or repairing this equipment; failure to
do so could result in property damage, product damage, injury, or (in very rare cases)
death. Make sure only authorized personnel operate this equipment. All repairs must
be performed by an authorized technician. Do not make modifications to the unit; this
voids the warranty and increases the chances of injury or property damage. Make
sure to read and follow the instructions in this manual and on the labels on the unit.
This manual is mandatory reading for all users of 10AP Series Two-Post
Lifts, including anyone who installs, operates, maintains, or repairs them. Always
keep this manual on or near the equipment. Technical support and service is
available from your dealer, on the Web at bendpak.com/support, by email at
support@bendpak.com, or by phone at (800) 253-2363, option 7, then 4.
Online chat is also available. Visit www.bendpak.com click the chat icon.
Scan this QR Code for up-to-date information and videos on the 10AP Lift series.