HD-9 Series Four-Post Lifts 64 P/N 5900123 — Rev. N2 — November 2023
To use the Caster Kit:
1. Raise the Lift to the first Safety Lock and engage it here.
2. Locate the components of the four Caster Kit assemblies.
3. Using the supplied hardware, bolt the four Casters to the four holes in the four Caster Kit Shafts.
4. Take one Shaft and put the open end around the Post, with the Shaft on the inside of the Lift.
The Cradle of the Shaft needs to be directly below the Crosstube.
5. Put the Pin through the holes in the Caster Kit assembly and the Post.
6. Put the Cotter Pin into place on the end of the Pin.
7. Repeat Steps 4 through 6 for the other three Caster Kit assemblies.
8. Lower the Lift to the ground.
Make sure the Crosstubes are going into all four Cradles on all four Caster Kit Shafts; this pushes
the Bases of the Posts off the ground so that you can move it.
9. Move the Lift to the desired location.
10. Raise the Lift to a locking position and engage it there.
⚠ WARNING Make sure the Runways are secured on a Safety Lock position before removing the
Caster Kit assemblies.
11. Take off all four Caster Kit assemblies.
Bleeding the Hydraulic Cylinder
The Hydraulic Cylinder on the Lift is self-bleeding, which means that in most cases any air in the
system can be removed by raising and lowering the Runways a few times, “bleeding” the Hydraulic
System of the unwanted air.
⚠ WARNING Before performing any maintenance on your Lift (for example, bleeding the
Hydraulic Cylinder or adding Hydraulic Fluid), make sure the Runways are fully
lowered and the power source has been completely disconnected. If your
To Next Page
