EasyManua.ls Logo

BendPak HD-9 Series - Page 68

BendPak HD-9 Series
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HD-9 Series Four-Post Lifts 68 P/N 5900123 — Rev. N2 — November 2023
Pushbutton Air Valve. Press
and hold the Pushbutton on the
Pushbutton Air Valve as part of
the process to lower the
Runways. Located on one side
or the other of the Power Unit
(depending on where it was
installed). Pressing and holding
the Pushbutton on the
Pushbutton Air Valve disengages
the Safety Locks, which is
needed to lower the Runways.
To raise Runways to a
Safety Lock:
1. Press and hold Up Button.
2. When just past desired
height, release Up Button.
3. Press & hold Lowering
Handle.
4. Runways stop going down
when engaged on a Safety
Lock; release Lowering
Handle when they stop.
Do not press and hold
Pushbutton.
To lower Runways:
1. Press the Up Button for a
second or two.
This disengages the
Runways from the Safety
Locks.
2. Press and hold Pushbutton
and Lowering Handle at the
same time.
Runways begin lowering.
3. When Runways are fully
lowered, release Pushbutton
and Lowering Handle.
4. Drive Vehicle off Runways.
Raising and Lowering Vehicles
Keep the following in mind when operating your Lift:
• Be safe. Make sure to check for people, pets, and objects that might be in the path of the Lift as you
raise or lower it. If there is something in the way, stop the Lift and move it out of the way. Watch the Lift
carefully as it raises and lowers.
⚠ DANGER Pay careful attention when you are raising or lowering your Lift. If a person or pet
becomes stuck under the Lift, they could be injured or, in rare cases, killed.
• The Power Disconnect Switch exists for a reason. We hope you never have to use it, but
if something unexpected occurs, use the Power Disconnect Switch to immediately stop the
Lift from moving.
• Retrieve what you need from the Vehicle before lifting it. It is frustrating to raise a
Vehicle and then realize you left something inside. Never raise your Lift with people in the
Vehicle.
• Make sure the Vehicle is balanced. If there is extra weight on one end or the other, remove
it or balance it before raising the Vehicle.
• Center the Vehicle’s wheels on the Runway. Centered wheels keep the Vehicle balanced.