BendPak HDS-14X - Step 18; Bleeding

29
STEP 18
(Bleeding)
1. Lift must be fully lowered before changing or adding
uid.
2. Raise and lower lift six times. The Cylinder is self-
bleeding. After bleeding system, uid level in power unit
reservoir may be down. Add more uid if necessary to
raise lift to full height. It is only necessary to add uid to
Raise lift to full height.
3. To pressure test, run lift to full rise and run motor
for approximately 3-seconds after lift stops. This will put
pressure on the hydraulic system. Stop and check all t-
tings and hose connections. Tighten or reseal if required.
POST-INSTALLATION CHECK-OFF
n Columns properly shimmed and stable
n Anchor Bolts tightened
n Pivot / Sheave Pins properly attached
n Electric power supply confirmed
n Cables adjusted properly
n Safety Locks functioning properly
n Check for hydraulic leaks
n Oil level
n Lubrication of critical components
n Check for overhead obstructions
n All Screws, Bolts, and Pins securely fastened
n Surrounding area clean
n Operation, Maintenance and Safety Manuals
on site.
n Perform an Operational Test with a typical vehicle