BendPak HDS-14X - Floor Plan; Specifications

9
MODEL HDS-14 HDS-14X
Lifting Capacity
14,000 /6350 Kg. 14,000 Lbs. / 6350 Kg.
Max Capacity Front Axle
7,000 lbs. / 3175 Kg. 7,000 lbs. / 3175 Kg.
Max Capacity Rear Axle
7,000 lbs. / 3175 Kg. 7,000 lbs. / 3175 Kg.
A - Overall Width
130”/ 3300 mm 130”/ 3300 mm
B- Outside Length
213” / 5408 mm 243” / 6170 mm
C- Overall Length
241” / 6131 mm 271” / 6894 mm
D- Height of Columns
92” / 2338 mm 92” / 2338 mm
E- Min Runway Height
7-3/4" / 196 mm 7-3/4" / 196 mm
F- Max. Rise
70” / 1778 mm 70” / 1778 mm
G- Max Lifting Height
77.5” / 1970 mm 77.5” / 1970 mm
H- Width Between Columns
120” / 3046 mm 120” / 3046mm
I- Runway Width
20” / 508 mm 20” / 508 mm
J - Width Between
Runways(*)
37.5” - 50”
953 mm - 1289mm
37.5” - 51.5”
953 mm - 1310mm
K- Length of Runways
199” / 5054 mm 236” 5816 mm
Min. Wheelbase @ Rated Capacity 140” / 3556 mm 170” / 4318 mm
Min. Wheelbase @ 75%Rated Capacity 120” / 3048 mm 145” / 3683 mm
Min. Wheelbase @ 50%Rated Capacity 100” / 2540 mm 120” / 3048 mm
Min. Wheelbase @ 25%Rated Capacity 80” / 2032 mm 95” / 2413 mm
Locking Positions
15 15
Lock Spacing
Every 4” / 102 mm Every 4” / 102 mm
Lifting Time
60 Seconds 60 Seconds
Standard Motor(**)
220 VAC / 60Hz 1 Ph. 220 VAC / 60Hz 1 Ph.
Emission sound pressure at Operator Position < 70 dB(A)
* This dimension may be limited with the addition of rolling jacks. See Rolling Jack Specications on Separate
page.
** For CE compliant countries see errata sheet included with control panel.
The design, material and specications are subject to change without notice.
FLOOR PLAN
*IMPORTANT NOTE*
Check Diagonal Measurements To Ensure Square Layout Diagonal Measurements Must Be Equal.