Why BendPak Lifting Systems jack raises load but does not stay up?
The BendPak Lifting Systems' Rolling Bridge Jack is designed for raising and lowering loads, not for indefinite holding without a Safety Lock. Ensure you engage the Safety Lock at the desired height. Also, check for Hydraulic Fluid leaks.
What to do if BendPak Lifting Systems jack does not lift load?
If your BendPak Lifting Systems jack isn't lifting, first ensure the load isn't too heavy. Then, verify the Rolling Bridge Jack receives appropriate air pressure and that the Air-Operated Hydraulic Pump has sufficient Hydraulic Fluid. Finally, check for dirt in the hydraulic system; if present, replace the Hydraulic Fluid and clean the system.
How to troubleshoot BendPak Lifting Systems jack that does not move along Utility Rail?
If the BendPak Lifting Systems jack isn't moving along the Utility Rail, ensure the Utility Rail Channels and Lips are free of obstructions. Also, confirm the Rolling Bridge Jack is correctly situated on the Utility Rail Channel or Lip. It is also important to check with BendPak to ensure the Rolling Bridge Jack is installed on an approved Lift.
Covers essential safety rules and warnings for operating the Rolling Bridge Jacks safely.
Mandatory safety precautions and training requirements for installing the equipment.
Lists required tools and steps for preparing the four-post lift for jack installation.
Essential safety guidelines to follow during normal operation of the rolling bridge jack.
Daily, weekly, and monthly maintenance tasks for the rolling bridge jack.
Provides solutions for common issues encountered during jack operation and setup.
General| Brand | BendPak |
|---|---|
| Model | RBJ4500 |
| Category | Lifting Systems |
| Language | English |
To Next Page
