Why BendPak Lifting Systems jack raises load but does not stay up?
The BendPak Lifting Systems' Rolling Bridge Jack is designed for raising and lowering loads, not for indefinite holding without a Safety Lock. Ensure you engage the Safety Lock at the desired height. Also, check for Hydraulic Fluid leaks.
What to do if BendPak Lifting Systems jack does not lift load?
If your BendPak Lifting Systems jack isn't lifting, first ensure the load isn't too heavy. Then, verify the Rolling Bridge Jack receives appropriate air pressure and that the Air-Operated Hydraulic Pump has sufficient Hydraulic Fluid. Finally, check for dirt in the hydraulic system; if present, replace the Hydraulic Fluid and clean the system.
How to troubleshoot BendPak Lifting Systems jack that does not move along Utility Rail?
If the BendPak Lifting Systems jack isn't moving along the Utility Rail, ensure the Utility Rail Channels and Lips are free of obstructions. Also, confirm the Rolling Bridge Jack is correctly situated on the Utility Rail Channel or Lip. It is also important to check with BendPak to ensure the Rolling Bridge Jack is installed on an approved Lift.
What to do if BendPak Jacks do not lift the load?
If your BendPak Jacks don't lift the load, there are several potential reasons. First, ensure that the load isn't too heavy. Second, verify that the jack receives the correct air pressure from the air supply. Also, check if the air hydraulic pump contains sufficient hydraulic oil. Finally, ensure that dirt hasn't entered the hydraulic system. If dirt has contaminated the system, replace the hydraulic oil and clean the system.
Why BendPak Jacks raises load but does not stay up?
If your BendPak Jacks raise the load but it doesn't stay up, ensure you put the jack into a locking position when the load reaches the desired height. Remember that the jack is designed to raise and lower loads; it isn't designed to hold a load indefinitely if the load is not in a locked position.
How to fix BendPak Jacks that do not move along utility rail?
If your BendPak Jacks don't move along the utility rail, ensure that the utility rail channel and lip are free of any obstructions. Also, make sure the jack is correctly situated on the utility rail channel or lip and is installed on an approved lift.
User obligations for safe operation and maintenance.
General safety advice and warnings for using the product.
Safety precautions and tools needed for installation.
Instructions on positioning the jack on the lift runways.
Positioning the pump and moving the jack onto the lift.
Critical safety guidelines for operating the rolling bridge jacks.
Step-by-step instructions for lifting and lowering vehicles.
Daily, weekly, and monthly maintenance tasks for the jack.
Solutions for jack not lifting, moving, or holding load.
General| Brand | BendPak |
|---|---|
| Model | RBJ7000 |
| Category | Lifting Systems |
| Language | English |
To Next Page
