RBJ Series of Rolling Bridge Jacks 22 P/N 5900004 — June 2018 — Rev. C2
Raising and Lowering
This section describes how to raise and lower your Rolling Bridge Jack.
To raise a vehicle on your Rolling Bridge Jack:
1. Drive the vehicle onto the Lift following the manufacturer’s instructions.
⚠ WARNING Make sure the arms of the Rolling Bridge Jack are fully lowered so they do not hit
the underside of the vehicle when the vehicle is driven onto the Lift. If a vehicle does
ever hit the Rolling Bridge Jack while being driven onto or off of the Lift, make sure
the Rolling Bridge Jack has not been damaged and that all Rollers are correctly
seated on or in the Utility Rail.
2. Position the tires of the vehicle in the center of each runway.
3. Set the parking brake on the vehicle and use a wheel chock to hold the vehicle in position.
4. Check the Utility Rail Channels to make sure nothing is in them that could obstruct the movement
of the Rolling Bridge Jack.
5. Check the area to make sure everyone is clear of the Lift and the Rolling Bridge Jack; make sure
there are no obstructions above the vehicle.
6. Position the Adjustable Arms of the Rolling Bridge Jack so the Lift Pads are under the vehicle’s
lifting points, as specified by the vehicle manufacturer.
⚠ WARNING Make sure to lift the vehicle at the correct lifting points. Lifting at the wrong location
could potentially damage the vehicle and/or the Rolling Bridge Jack.
7. Press and hold the PUMP end of the pedal to begin raising the Rolling Bridge Jack.
To Next Page
Loading...
