RBJ Series of Rolling Bridge Jacks 23 P/N 5900004 — June 2018 — Rev. C2
8. When the Rolling Bridge Jack reaches the desired height, release the PUMP end, then press and
hold the RELEASE end to lower the Rolling Bridge Jack onto the nearest Safety Lock.
9. Release the RELEASE end of the pump when the Jack settles on the Safety Lock.
To lower a vehicle:
1. Press the PUMP end of the pedal for about two seconds; this raises it a little, moving it off the
Safety Lock Pin.
It is difficult to move the Safety Handle out of the way if it is still on the Safety Lock Pin.
2. Pull the Safety Handle up out of the way, then press and hold the RELEASE end of the pedal.
The Rolling Bridge Jack begins lowering.
3. When the Jack is fully lowered, release the RELEASE end of the pedal.
To Next Page
Loading...
