RBJ Series of Rolling Bridge Jacks 28 P/N 5900004 — June 2018 — Rev. C2
RBJ4500 Adapter Kit
The RBJ4500 Adapter Kit is a four-piece kit that increases the capabilities of the RBJ4500 Rolling
Bridge Jack by providing sliding adapters that mount on the main center tube.
Note: This Adapter Kit only works with the RBJ4500 Rolling Lift Jack; it cannot be used with
other models.
The Adapter Kit includes:
• Two low-profile sliding rubber contact pads
• Two sliding receivers that accommodate the standard RBJ4500 Lift Pads or stackable adapters
This image shows the short round Lift Pad on the left and the Lift Pad base on the right.
This image shows how to slide the adapters into place. You can adjust the positions of the adapters
so that the Lift Pads make contact with the appropriate lifting points for the vehicle you are lifting.
Visit the website page for the Adapter Kit for more information.
To Next Page
Loading...
