BendPak XPR-10 Series User Manual

XPR-10 Series Two-Post Lifts 17 P/N 5900951 — Rev. D — May 2019
• If you are installing a Symmetric model, the Powerside Post can go on either side as you are
looking at the Lift. Put the Post with the Mounting Bracket on the side you want, no other changes
are necessary. How do you make this decision? One factor is: where is the power source—you
generally want the power source as close as possible to the Power Unit. Otherwise, pick the side
that works best for the site and/or get the opinion of the Lift owner.
• If you are installing an Asymmetric Lift, the Powerside Post and the Power Unit must go on the
right. The 30 degree angles of the Posts of an Asymmetric Lift must face the Rear of the Lift.

BendPak XPR-10 Series Specifications

General

Brand	BendPak
Model	XPR-10 Series
Category	Lifting Systems
Language	English