2727
IMPORTANT POWER-UNIT
INSTALLATION NOTES
nDO NOT run Power Unit with no oil. Damage to pump can occur.
nThe Power Unit must be kept dry. Damage to Power Unit caused by water or other liquids such as
detergents, acid etc., is not covered under warranty.
nImproper electrical hook-up can damage motor and will not be covered under warranty.
nMotor can not run on 50HZ without a physical change in motor.
nUse a separate breaker for each power unit.
nProtect each circuit with time delay fuse or circuit breaker.
nFor 208-230 volt, single phase, use a 25 amp fuse.
nFor 208-230 volt, three phase, use a 20 amp fuse.
nFor 380-440 volt, three phase, use a 15 amp fuse.
Installation and adjustment.
DO NOT attempt to raise vehicle until a thorough operation check has been completed.
All wiring must be performed by a certified electrician only.
DANGER!
DO NOT PERFORM ANY MAINTENANCE OR
INSTALLATION OF ANY COMPONENTS WITH OUT
FIRST ENSURING THAT ELECTRICAL POWER HAS
BEEN DISCONNECTED AT THE SOURCE OR PANEL
AND CANNOT BE RE-ENERGIZED UNTIL ALL
MAINTENANCE AND/OR INSTALLATION
PROCEDURES ARE COMPLETED.
SEE WIRING INSTRUCTIONS AFFIXED TO
MOTOR FOR PROPER WIRING INSTRUCTIONS.
To Next Page
Loading...
Need help?
General
