Page6
9. I2C slave machine address configuration ID_I2C_SLAVE_ADDR=0x0B ....................... 28
10. Restore default setting ID_RESTORE_DEFAULT=0x10 ................................................ 29
11. Save current setting ID_SAVE_SETTINGS=0x11........................................................... 29
12. Output product bar code ID_READ_MANU_BIN=0x12 ................................................ 29
13. Get full-length version number ID_GET_FULL_VERSION=0x14 ................................. 30
14. Amp threshold setting ID_AMP_THRESHOLD=0x22 ................................................... 30
15. Switch between Single Frequency and Dual Frequency ID_ DEALIAS_EN =0x29 ......... 30
16. Timestamp synchronization ID_TIMESTAMP_SYNC =0x31 ......................................... 31
17. Enable/disable Power saving mode (ECO) ID_LOW_CONSUMPTION=0x35 ............... 31
18. Filter Setup ID_FILTER_BIT_MAP=0x39 ..................................................................... 31
19. Distance limit setting ID_DIST_LIMIT=0x3A ................................................................ 32
20. Enable/disable on-off mode ID_ON_OFF_MODE=0x3B ............................................... 32
21. Read config by id ID_GET_CONFIG_PARA=0x3F ....................................................... 32
22. Ultra-low Power Mode ID_ ULTRA_LOW_POWER_MODE=0x58 .............................. 33
23. Frequency Calibration ID_FREQ_CNT_CALIB=0x59 ................................................... 33
Appendix III I2C register table ........................................................................................................ 34
To Next Page
Loading...
