Bennett Read DYNAMITE - Cleaning the Post-Motor Filter

STEP 2
STEP 3
8
MAINTENANCE AND CARE
CLEANING THE
POST-MOTOR FILTER
The post-motor lter (17) assists in
the ltration process to return
cleaner air into the room
STEP 1:
Unplug the vacuum from the electrical
outlet
STEP 2:
Remove the lter door (16) by pulling up
on the tab, then pulling out and away from
the vacuum
STEP 3:
Remove the post-motor lter from the
vacuum
STEP 4:
The post-motor lter can be hand washed
in cold water with a mild detergent.
Rinse well and air dry completely
before placing back into the vacuum
STEP 5:
When dry, replace the post-motor lter into
the lter cavity
STEP 6:
Replace the lter door by placing the two
tabs on the top of the lter door into the
notches on the top of the post-motor lter
compartment and pushing the tab forward
into the vacuum to lock into place.
For maximum cleaning performance check the
lters often and clean or replace them regularly.
TIP:
Never operate your DYNAMITE vacuum with
damp or wet lters, or without all lters in place.
!
WARNING:
This product is intended for household use only
and not for commercial or industrial use.
Vacuuming of dust from products like plaster,
concrete or ashes will damage the motor and
void the guarantee.
NOTICE:
STEP 6
STEP 5
STEP 7