English
30
Operations
Likewise, when you wish to switch from the Advanced OSD menu to the Basic OSD menu,
follow the instructions below:
1. Go to Advanced Menu - System > Menu Settings and press OK.
2. Select Menu Type and OK.
3. Press / to select Basic. Next time when you turn on the projector, you may access the
Basic OSD menu by pressing MENU.
Securing the projector
Using a security cable lock
The projector has to be installed in a safe place to prevent theft. Otherwise, purchase a lock, such
as a Kensington lock, to secure the projector. You can locate a Kensington lock slot on the left
side of the projector. See "Kensington anti-theft lock slot" on page 11 for details.
A Kensington security cable lock is usually a combination of key(s) and a lock. Refer to the lock’s
documentation for nding out how to use it.
Utilizing the password function
Setting a password
1. Go to Advanced Menu - System > Security Settings. Press OK. The Security
Settings page appears.
2. Highlight Change Password and press OK.
3. The four arrow keys ( / / / ) respectively
represent 4 digits (1, 2, 3, 4). According to the
password you desire to set, press the arrow keys
to enter six digits for the password.
4. Conrm the new password by re-entering the new
password.
Once the password is set, the OSD menu returns
to the Security Settings page.
5. To activate the Power On Lock function, press / to highlight Power On Lock and
press OK. Press / to select On. Input the password again.
• The digits being input will display as asterisks on-screen. Make a note of your selected password and keep
it in a safe place in advance or right after the password is entered so that it is available to you should you
ever forget it.
• Once a password has been set and the power on lock is activated, the projector cannot be used unless
the correct password is entered every time the projector is started.
If you forget the password
If you enter the wrong password, the password error
message will appear, and the Input Current Password
message follows. If you absolutely do not remember the
password, you can use the password recall procedure. See
"Entering the password recall procedure" on page 31.
If you enter an incorrect password 5 times in succession, the
projector will automatically shut down in a short time.
To Next Page
Loading...
