English
4
Important safety instructions
Important safety instructions
Your projector is designed and tested to meet the latest standards for safety of information
technology equipment. However, to ensure safe use of this product, it is important that you follow
the instructions mentioned in this manual and marked on the product.
1. Please read this manual before you
operate your projector. Save it for future
reference.
2. Do not look straight at the projector
lens during operation. The intense light
beam may damage your eyes.
3. Refer servicing to qualied service
personnel.
4. In some countries, the line voltage is
NOT stable. This projector is designed
to operate safely within a mains voltage
between 100 to 240 volts AC, but could
fail if power cuts or surges of ±10 volts
occur. In areas where the mains
voltage may uctuate or cut out, it is
recommended that you connect your
projector through a power stabilizer,
surge protector or uninterruptible
power supply (UPS).
5. Do not block the projection lens with
any objects when the projector is under
operation as this could cause the objects
to become heated and deformed or even
cause a re. To temporarily turn off the
light source, press ECO BLANK on the
remote control.
To Next Page
Loading...
