18 Positioning your projector
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the top or
bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually correct it
following one of these steps.
• Using the remote control
Press / on the projector or remote control to display the
Keystone correction page. Press to correct keystoning at
the top of the image. Press to correct keystoning at the
bottom of the image.
• Using the OSD menu
1. Press MENU and then press until the Display menu is
highlighted and press OK.
2. Make sure that Auto Vertical Keystone is Off.
3. Press to highlight Keystone and press OK. The
Keystone correction page displays.
4. Press to correct keystoning at the top of the image or press to correct keystoning at the
bottom of the image.
To Next Page
Loading...
