2. The sample for EMI agency approval should be under 4 dB of the limit.
The production pilot run units should be under 3 dB of the limit.
The mass production units should be under 1 dB of the limit.
2.7 Reliability
1.
The prediction MTBF of display unit shall be greater than 60,000 hours excluding the lamp. (at 25
℃
)
2. Lamp lifetime: 30,000 hrs minimum at which brightness of lamp is 50% compare to that of initial value at
7.0mA and 25
℃
.
2.8 Mechanical Design for TCO 99:
1) Front Frame Reflectance:
* diffuse reflectance: > 20%
* Gloss <= 30% gloss unit
2) Labeling of plastics:
Plastic weight > 25g shall be marked in accordance with ISO11469
3) Variety of Plastic:
All plastic components that weight > 100g shall be made from the same type of plastic.
4) Painting of Plastic:
*Any plastic components that weight >100g shall not be painted lacquer or vanished, so that the paint, lacquer or
vanish in dry matter exceed 1 weight-% of the plastic component.
* Mould decoration (IMD) is not allowed
* All paints, lacquers, vanishes or colour additives used shall be declared by the type and mount.
5) Metallization of Plastic Housing:
* Metallization is not allowed.
6) Plastic components > 25g shall not contain retardants of organically bound chloride or bromide.
2.9 Environment Protection Design:
Product is Per ES 715-c49 Environment Design Guide
2.10 Acoustical Noise
With the display operating, the issue of sound measured is contained within 40 dB/A in the audible field.
3. Input / Output Signal Specification
3.1 Input Signal Requirements
3.1.1 Signal cable
(1) Analog Video Inputs:
15pin D-sub connector is on the captive signal cable for IBM VGA, compatible graphic adapters.
The pin assignment of this connector is described as below:
To Next Page
Loading...
Need help?
General
