14
Adding a new remote control
A remote control may be supplied with your projector and the QS02 dongle
respectively. You can work with a remote control purchased separately.
The projector pairs and works with one remote control during initial setup.
If you prefer to work with another remote control, add it to the device list
first.
1. Go to
> Remote and accessories from the ATV home screen.
2. Select Add accessory.
3. Wait for a few seconds until you are prompted with the pairing screen
of the ATV's remote control. If you prefer to pair with QS02's remote
control, follow the on-screen instructions. If you prefer to pair with
another remote control, check its quick start guide or user manual for
pairing procedures.
To Next Page
Loading...
