15
Connections
The following illustrations are for your reference only.
Connect power
1. Plug one end of the power cord into the power jack on the display and the other end into an
appropriate power outlet.
2. Set the power switch to ON (I). The system will enter standby mode.
21
• The supplied power cord is suitable for use with 100-240V AC power only.
• The power cord and outlet illustrated may differ from the ones used in your region.
• Only use an appropriate power cord for your region. Never use a power cord which appears damaged or
frayed, or change the plug type on the power cord.
• Be aware of the power loading when you use extension cords or multiple outlet power boards.
• There are no user serviceable parts in this display. Never unscrew or remove any covers. There are
dangerous voltages inside the display. Turn off the power and unplug the power cord if you intend to move
the display.
Turn the display on or off
• To turn on the display, press the power button on the control panel or on the remote control.
• To turn off the display, press the power button on the control panel. The system will
automatically enter standby mode.
Signal receiver
Power button
The display’s standby mode still consumes power. To completely cut off power supply, set the power switch
to OFF (O) and then disconnect the power cord from the power outlet.
To Next Page
Loading...
Need help?
General
