BenQ SL461A - OPS Module Installation;Removal

3
1.5. Installing and Removing OPS module (SL461A) (optional)
To install OPS Module:
1. Power off the display.
2. Remove the cover of OPS after take screw off.
3. Insert OPS module and then x by screw.
4. After inserting the stand in the guide block, tighten the screws on both sides of the display.
NOTE: Keep the OPS cover for future use.
Screw
OPS
Screw
To remove OPS Module:
1. Power off the display.
2. Remove screw and plug out OPS module.
3. Install OPS cover and then x by screw.