20 Operation
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message “Out of Range” displayed on the background screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See Timing chart on
page 50.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
• If “Reset All Settings” is selected, setup wizard will appear after reboot, and Auto Source will be reset to
default value.
To Next Page
Loading...
