BenQ V5000i - Operation Settings and Upgrades

Menu operation 44
Information menu
Operation
Settings
Reminder Message
Sets the reminder messages on or off.
LED Indicator
You can turn off the LED warning lights. This is to avoid any light disturbance
when viewing images in a dark room.
Power On/Off Settings
• Direct Power On
Allows the projector to turn on automatically once the power is fed through
the power cord.
• Auto Power Off
Allows the projector to turn off automatically if no input signal is detected
after a set period of time to prevent unnecessary waste of lamp life.
BenQ HDMI Media Streaming (QS02)
Enables or disables functions related to Android TV dongle (QS02).
Firmware
Upgrade
Updates the projector firmware via the 1.5A SERVICE USB-A port at the rear
of the projector.
Factory
Default
Returns all settings to the factory preset values.
The following settings will still remain: 2D Keystone, Projector Position, Light Source
Information, Security Settings, Baud Rate, and High Altitude Mode.
Reset System Returns all the settings on the System menu to the factory default values.
Information See Information on page 33.