51
Step 3:
The System will be not under <1W condition before you programming flash updated.
Projector is in STAND BY mode.
Make sure the USB cable is firmly attached between projector and computer.
Press holds the <Left> keys and connects the power cord to the projector at same time,
The Temp LED (Orange) will blink flashing and please make sure the system is not into
<1W stay.
Press <Down>, <Up>, <Right>, <Up> keys in sequence using keypad buttons, or using
the IR remote controller for those with limited keypads.
The power and lamp LED will blink and the Flash-Tool mode will be enabled.
Step 4: Press the “Choose” button to locate the new splash logo.
Select the image type in either BMP or JPG in the “File of type” option.
The Windows hardware wizard will pop up if the USB device driver is not installed.
Simply select the recommended options, and let Windows Wizard does the trick.
BMP/JPG selection
To Next Page
Loading...
