97
Interface setting
RS232 Protocol
Baud Rate 115200 bps (default)
Changeable
(2400/4800/9600/14400/19200/38400/57600/115200)
* Need following set the same value between of Hyper
terminal and OSD Baud Rate setting.
Data Length 8 bit
Parity Check None
Stop Bit 1 bit
Flow Control None
Software specification
1. Each input character will be echoed and All the echo text will be same with the command
you execute except query command
2. When give “Enter”(ASCII 13), it will echo 3E,00. It means projector is ready to accept
RS-232 command.
3. If no any command, it should echo 0D,0A,00 after 5 seconds.(5 sec time out)
4. If the command format is illegal, it will echo “Illegal format”.
5. If the command format is correct, but it is not valid for this model, it will echo “Unsupported
item”.
6. If the command format is correct, but can’t be execute in some condition, it will echo “Block
item”.
Note: 1.Item 5 and item 6 is not support at power saving mode (standby power < 1W).
2.Each input upper case and lower case character should be action.
To Next Page
Loading...
