BenQ W700 - Command Table for Projector Control

98
Command Table
Function Type Operation ASCII
Write Power On <CR>*pow=on#<CR>
Write Power off <CR>*pow=off#<CR>
Power
Read Power Status <CR>*pow=?#<CR>
Write COMPUTER/YPbPr <CR>*sour=RGB#<CR>
Write COMPUTER 2/YPbPr2 <CR>*sour=RGB2#<CR>
Write Component <CR>*sour=ypbr#<CR>
Write DVI-A <CR>*sour=dviA#<CR>
Write DVI-D <CR>*sour=dvid#<CR>
Write HDMI <CR>*sour=hdmi#<CR>
Write HDMI 2 <CR>*sour=hdmi2#<CR>
Write Composite <CR>*sour=vid#<CR>
Write S-Video <CR>*sour=svid#<CR>
Write Network <CR>*sour=network#<CR>
Write USB Display <CR>*sour=usbdisplay#<CR>
Write USB Reader <CR>*sour=usbreader#<CR>
Source Selection
Read Current source <CR>*sour=?#<CR>
Write Mute On <CR>*mute=on#<CR>
Write Mute Off <CR>*mute=off#<CR>
Read Mute Status <CR>*mute=?#<CR>
Write Volume + <CR>*vol=+#<CR>
Write Volume - <CR>*vol=-#<CR>
Read Volume Status <CR>*vol=?#<CR>
Write Mic. Volume + <CR>*micvol=+#<CR>
Write Mic. Volume - <CR>*micvol=-#<CR>
Audio Control
Read Mic. Volume Status <CR>*micvol=?#<CR>
Write Dynamic <CR>*appmod=dynamic#<CR>
Write Presentation <CR>*appmod=preset#<CR>
Write sRGB <CR>*appmod=srgb#<CR>
Write Bright <CR>*appmod=bright#<CR>
Write Living Room
<CR>*appmod=livingroom#<CR>
Write Game <CR>*appmod=game#<CR>
Write Cinema <CR>*appmod=cine#<CR>
Write Standard <CR>*appmod=std#<CR>
Write User1 <CR>*appmod=user1#<CR>
Write
User2 <CR>*appmod=user2#<CR>
Write
User3 <CR>*appmod=user3#<CR>
Read
Picture Mode <CR>*appmod=?#<CR>
Write
Contrast + <CR>*con=+#<CR>
Write
Contrast - <CR>*con=-#<CR>
Read
Contrast value <CR>*con=?#<CR>
Write
Brightness + <CR>*bri=+#<CR>
Write
Brightness - <CR>*bri=-#<CR>
Picture Mode
Read
Brightness value <CR>*bri=?#<CR>