EasyManua.ls Logo

Bentel Security B3G-220 - Page 33

Bentel Security B3G-220
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
220 Series 33
Pay as you go balance check
To check your pay as you go balance with an SMS, you can either use the Console (see “Pay As You Go Balance” on page 42)
or send an SMS composed of the characters #CCC followed by * and the user code, as follows:
#CCC*User code*
or #ICCC followed by * and the installer code, as follows:
#ICCC*Installer code*
You will receive an SMS with the pay as you go balance.
At the GSM service provider's discretion, the prepaid SIM card pay as you go balance service may be suspended.
If the EN50136 option is enabled, the installer must be authorised by the normal user for the command to work.
Checking the expiration date
To find out the expiration date of the SIM card with an SMS, send an SMS composed of the characters #EDC followed by * and
user code, as follows:
#EDC*User code*
You will receive an SMS with the expiration date.
Updating the expiration date
To update the SIM card's expiration date with an SMS, send an SMS composed of the characters #EDU followed by *, the user
code and the new date, as follows:
#EDU*User code*new date*
The date must have the format DD/MM/YYYY.
If an expiration date has NEVER been set on the Console, the expiration time is set to 10:00 AM.
If a date and time of expiration have been set with the Console and you then change the expiration date with an SMS using
the command #EDU, the expiration time is unchanged.
Checking the serial number
This command is used to check the communicator's serial number with an SMS composed of the characters #RID followed by *
and the user code, as follows:
#RID*User code*
or #IRID followed by * and the installer code, as follows:
#IRID*Installer code*
The device will respond with the RID: 01234567.
Enabling the installer
To enable the installer to work with the device, the user must send a SMS composed of #ENI followed by the User code as follows:
#ENI*User code*
The device will confirm with an SMS.
The installer must be enabled only if the EN 50136 option is enabled; if not, the installer is always enabled.

Related product manuals