50 Universal Cellular Communicator
Supervision Time 1: set the supervision time. Range: 60 to 65535 s, in 1 s steps.
In order to ensure conformity with EN 50136-2 supervision must be enabled and the Supervision Time must be no more than
3 minutes.
Receiver 2
The options for Receiver 2 are the same as those for Receiver 1, except for the differences described below.
If Receiver functionality mode for receiver 1 is Not Used, you can NOT set the options for receiver 2: transmission of CID/
SIA events to the central station is disabled.
Receiver functionality mode: if Receiver functionality mode for receiver 1 is Primary, receiver 2 may be:
Not Used, receiver 2 is disabled, the communicator sends the CID/SIA to receiver 1 only (this mode is called “single mode”);
Backup, the communicator sends the CID/SIA messages to receiver 1 and, should it not be operational or reachable, sends
them to receiver 2 (this mode is called “Main + Backup”);
Redundant, the communicator sends the CID/SIA to both receiver 1 and receiver 2 simultaneously and sends the ACK
(confirmation of reception) to the panel only if both receivers confirm reception (this mode is called “Redundant”).
Voice Messages
This page enables you to record and play back voice messages: refer to “SMS/Voice Calls” on page 46, for how to associate
messages to events.
The voice messages can be recorded with a microphone connected to the PC, you can load pre-recorded messages from the PC
(hard disk, LAN, USB key, etc.) or you can import voice messages from another communicator, as described in paragraph
“Programming/Audio Import/Export” on page 38”.
The Console can import all type of audio files in the WAVE format (.WAV).
Play button: press this button to play back a voice message.
Record button: press this button to start recording a new voice message.
Stop button: press this button to stop playing back or recording the current voice message.
Pause button: press this button to pause playing back or recording the current voice message.
Clear button: press this button to delete a voice message saved in the communicator.
Open button: press this button to load a voice message from a PC resource (hard disk, LAN, etc.).
Save button: press this button to save a voice message to a PC resource (hard disk, LAN, etc.).
While a message is being recorded, a progress bar indicates the duration so far.
To Next Page
Loading...
