42 Universal Cellular Communicator
Black List Enabled: if enabled, the communicator accepts ONLY calls from numbers whose White List option is
enabled (see “Phonebook” on page 39).
The Black List function COMBINED with Activate Output on Caller ID delays call refusal by a few seconds. The
confirmation ring tone associated with Activate Output on Caller ID delays call refusal by a few seconds. If the call is refused
immediately, the output has not been activated.
Tones: select the country of Communicator installation; the selected country will set adequately a series of parameters for
the proper working of the simulated telephone line.
Roaming Enabled: enables GSM roaming.
Priorities
This options allows you to configure some priorities on the communicator relating to alarm event transmission.
Dialer / LI Priority: defines the priority of the communicator (send voice messages, SMS and digital messages to central
station receivers) and the LI (events transmitted by devices hooked up to the LI terminals, such as a burglar alarm panel).
Dialer Events Priority: sets the priority of the communicator (e.g. 1:Rx; 2:Ring; 3:Digital Calls; 4:Voice Calls;
5:SMS).
Generic
This section sets the loudness of the GSM communicator's speaker and microphone.
Speaker Volume: set the communicator's speaker volume: change this setting if the panel connected to terminals LI of the
communicator is unable to decode the DTMF commands.
Microphone Volume: set the communicator's microphone volume: change this setting if the user is unable to understand
the voice messages sent by the panel connected to terminals LI of the communicator or by the communicator itself.
A high microphone volume setting can corrupt the DTMF tones from devices connected to terminals LI, and make them
incomprehensible.
Enable Antenna Cut Detection: if enabled, the Antenna Fault event is tripped when the antenna is not present or in
short circuit.
Enable Battery Detection: if enabled, the Battery Fault event is tripped when battery faults are detected.
Automatic Clock Adjust
The options of this section is for the automatic synchronisation of the communicator's clock.
SIM Phone Number: enter the phone number of the SIM card in the communicator (up to 16 digits).
Auto SMS: if enabled, the communicator updates the system date and time by sending an SMS to the number specified in
the SIM Phone Number option. Factory setting: enabled.
IP Clock Adjust: if enabled, the communicator gets the date and time from the IP receiver 1, when configured and
connected. Factory setting: enabled.
In order to ensure compliance with EN 50136-2, the Auto SMS and IP Clock Adjust options must be enabled.
Pay As You Go Balance
At the service provider's discretion, the prepaid SIM card pay as you go balance service may be suspended.
This section configures the system so that an SMS containing the service provider's pay as you go balance information is
periodically sent to the first number in the Phonebook. Program the following options for a proper pay as you go balance request,
depending on the service provider in question:
Enquiry Type: select the type of request (none, SMS, Call, Service Command).
Enquiry Number: telephone number to call or to which an SMS message should be sent in order to request credit balance
information.
Balance Message: string used in the SMS requesting the balance using network commands.
To Next Page
