Bentone B 40 - Electrical Component Replacement

33 Bentone
!
Whenservicing/replacingcomponentsthataectcombustion,
uegasanalysisandsoottestmustbecarriedoutfollowing
installation.
165 105 11-3
7.7 Replacement of electrical components
1. Disconnect the main power and switch off the fuel supply.
2. Note the connection of the existing component and disassemble.
3. Fit new component with same connection or with specied alternative
connection.
4. Switch on the main power and check the operation of the new
component.
5. Start burner and check/adjust combustion.
!
Beforeobtainingaccesstoterminals,
allsupplycircuitsmustbedisconnected.