Beretta Ciao C.A.I - Error Signal Inspection: Flame Control System Blocked

51
caldaie
Failure to reach maximum heating Temperature selected Check position of corresponding potentiometer.
capacity See section 2.2 page 15
Failure to reach minimum heating Temperature selected Check position of corresponding potentiometer.
capacity See section 2.2 page 15
Smell of gas Leakage from supply Check system joint sealing.
system See section 7.2 page 71
Water leaking from bottom of boiler Problems with boiler Check system joint sealing.
plumbing See section 7.1 page 71
Safety valve starts Check filling pressure of system
working See section 7.4 page 72
Low production of sanitary water Temperature selected Check position of corresponding potentiometer
See section 2.2.3 page 12
PROBLEM CAUSE REMEDY
INDICE
• Failure to reach maximum heating capacity page 51
• Failure to reach minimum heating capacity page 51
• Smell of gas page 51
• Water leaking from bottom of boiler page 51
• Low production of sanitary water page 51
PROBLEM DETECTION TABLE FOR USER
!!
Contact Servicing Centre if problem
persistis after above operations.
!!
Contact Servicing Centre if problem
persistis after above operations.
!!
Contact Servicing Centre if problem
persistis after above operations.
!!
Contact Servicing Centre if problem
persistis after above operations.
!!
Contact Servicing Centre if problem
persistis after above operations.
!!
Contact Servicing Centre if problem
persistis after above operations.