SETUP CTR - VIBRATO - DEPTH
Main vibrato level control. OFF disables manual vibrato completely.
OFF – Vibrato lever disabled.
1 – Lowest vibrato depth setting
..
9 – Highest vibrato depth setting
The factory default setting is 4. Vibrato depth is also depending on the
vibrato sensitivity settings. After fine tuning the lever and bite sensitivity for a
smooth vibrato response, you may want to revisit the depth setting.
SETUP CTR - VIBRATO - RETURN
This setting lets you adjust the speed of the automatic return to zero for the
vibrato. Values go from 0 to 4, where 4 is the fastest return and 0 is no
automatic return, i.e. the vibrato lever will work as a conventional pitch stick.
Normal EWI/EVI behavior is auto return, and the default setting is 2. Setting 0 is
not recommended with bite sensor vibrato.
SETUP CTR - VIBRATO - DIRECTION
This setting lets you set the direction of the vibrato. For most people this
should be kept to the default setting NRM (normal), where the pitch will fall in
response to thumb movement in direction away from the mouthpiece, or rise in
response to bite when bite sensor is used for vibrato. Setting REV will simply
switch directions.
To Next Page
Loading...
Need help?
General