Prepare the Work Area. Start by
disconnecting the ground wire from the
starting batteries. Set up your work
light, clear the sleeper compartment of
loose items, and remove the divider
curtain if there is one. Then remove the
mattress.
Remove Aluminum Bunk Decking
Remove the screws securing the center
panel of the bunk deck (A) exposing the
center storage area (B).
Roll Floor Insulation Back. Pull up
the floor insulation and roll it back out
of your way as shown.
Attention: The evaporator blower in the Phoenix will not rotate.
This unit will always be side discharge!
To Next Page
Loading...
